Decking project 10

The decking staircase at the end of the deck, served as access and egress points both to the garden and also to the side of house footpath. Balustrade was necessary because of the height at the end of the deck. The deck staircase mad for an interesting and very practical feature at deck end.

Note that all the risers are at the same height. A common mistake is to try and 'fit' decking steps to the difference in level. Far better - and safer to provide standard riser heights - of maximum 22cm (5.5in). Do NOT allow for 6in risers - even if seemingly eraser to calculate.

A useful addition to most decks is the provision of a power source. in this case, two 13amp socket were place to the front edge of the deck to allow for lawnmower and other electrical garden tools.

All exterior electrical work should ideally be carried out by a competent, qualified electrician.

If you feel competent, and it is your own property, this type of deck fitting is an easy enough task. The main points to address being the secure fixing of the unit. As it protruded from its fixing surface on the deck, it was positioned under the front overhang to prevent accidental damage.

The unit is fitted with waterproof seals, and extra care must be taken to ensure that they are put in place with no crimping of the seals.

 

The finished result of a deck that made for considerably increased 'garden' space and of course was extensively used for those pleasant moments in the evening sun that we all enjoy.

Always ensure that you deck will actually have the floor space to make it an area that can be used for all manner of purposes - from doing the ironing on a nice day, to enjoying the al fresco meal or drink.

Be aware of the often overlooked little problems that can occur with a slightly raise patio deck terrace - especially the height of the finished article in relation to the overhang of the roof of the house. 

<<<Back a page   <<< Back to Decking Project Index Page